How to Create Your Own Dog Mask – The Basics

In this article we’re going to look at how to create your own dog mask. We’ll cover the basics and then go on to take a look at some of the more advanced tips and tricks which you can use.

For those who have a dog that likes to bark, and especially if your dog loves to play in the garden and other regions of the home, you need to get them some special dog protection.

Paper Plate 3d Dog Mask DIY Materials: This is the initial part of the set-up which will look a little scary at first, but it is really very straightforward. All you’ve got to do is take a cardboard cutting board and cut the cardboard into the shape of your mask. You can’t just cut a rectangular shape from the cardboard, so you’ll have to cut around the edge of the mask so that you get something that looks like a cone. The most important thing here is to be realistic with what kind of paper plate which you’re using.

Then you’ll have to wrap the cardboard around the edges of the paper plate, making sure there is a good seal between the two pieces so that you can make certain that nothing will leak when you put the mask on. Be sure the edges are cut so the edges aren’t sharp, as this can damage the edges of the mask.

Glue it on! The next step involves using some paint. You ought to spray the paint over the cardboard, making sure that it runs smoothly and evenly across the entire mask. You’ll want to start with one side of the mask , so that you can work your way round it before moving onto the other side. The paint has to be slightly thicker than the cardboard, and it is best that you leave about one-fifth of an inch of paint on the edges so that it runs across the cardboard.

Don’t worry too much about the paint getting stuck into your mask. It’s easy to eliminate it later, and it will leave you with a nice finished mask to show off to everyone! It’s also a good idea to wash away any excess paint after you’re done, so you don’t end up with smudges or smears on your dog.

Then it’s time to glue the mask on http://www.gymkren.cz/?p=17612 your dog’s head. First you need to make sure that you have a secure fit between the mask and your dog’s head. Once you’ve made sure that it’s secure, then you can begin to glue the mask on the dog’s face. Take the piece of cardboard that is used for the foundation of the mask and then fold it over. Be certain it’s quite powerful and then use your hands to secure the cardboard down in place.

Keep your hands out of the way and use tape to hold it in place as you repeat the procedure on the cardboard folds until you’ve got the mask snugged securely onto the surface of your dog. Don’t make the folds too large or else it might look messy. Once you’ve done this, you can then take out the mask and then attach the cardboard ears. And attach the other part of the mask onto the dog. Make certain the ears are level and make certain it is not too short or long as this will cause some issues with the mask slipping off the dog’s face.

If you’re using a dog mask because your dog protection, you will have to do some sanding to make certain it’s secure on your dog. You can do it by sanding off any excess paper that may have been removed from your mask.

Leave a Reply

Your email address will not be published. Required fields are marked *